Installation on air dampers (friction-locked axle connection)

To install a friction-locked axle connection (divergent damper shafts on the device) the accessory KB-S (Accessories) is required. The same applies for spring pre-tensioning as for the interlocking axle connection.

1

Clamping device

2

Rotation lock

  1. Insert the clamping device into the rotary drive and screw it from the opposite side using the Allen key.
  3. Twist two screws into the drive unit as a rotation lock limit so that they can still move in the slot for the rotation lock.
  4. Fix the rotation lock to the device.
  6. Mount the drive on the drive shaft. Position and mount it in the rotation lock so that it can gently swing to compensate for the non-central connection. For this reason, the screws should not be firmly tightened. Gentle movements in the slots must be possible.
  8. Tighten the clamping device with the spanner.
  1. The rotary drive has now been correctly installed.